Auto 16Pin OBD Extension Cable Male to 3 Female Y J1962 Connector Adapter Switch

Description

OBD II 1 x Male 16 pin J-1962 and 3 x Female 16 Pin J-1962 Ultra Flat low profile connectors
Direct pass through on pins 2, 4, 5, 6, 7, 10, 14, 15, 16 ,Ideal for use with GPS trackers for the most discrete installations.
Ideal for use with GPS trackers Auto Scanner Adapter Connector for the most discrete installations
This OBD2 splitter Cable will allow you to split out one OBD II port into Three OBD II devices to the vehicle at the same time to save more room
Direct pass through on pins 1, 2, 4, 5, 6, 7, 10, 14, 15, 16. Supports all standard passenger vehicle OBD 2 protocols
A nice solution for 3 separate things simultaneously
Your car MIGHT NOT let you run 3 separate things of the OBD simultaneously,but this great item allows you to do multiple things simultaneously;
Compact size,Flat Thin and Easy to fold
The compact size of the plugs though fit very nicely behind the dash of car, being flat cables really helps as it prevents tangles.
The cable was flexible enough with 50cm 20" long that you are able to conceal all of it behind the dash.
Description:
This is low profile and fits nicely into the cars OBD2 port;
This cable are flexible and allow you to plug the hotspot in then tuck it under the dash out of the way;
The splitter cable allows both devices to work properly, in parallel.
It can be works with ELM 327 ODB2 interface and other OBD device, it can be work correctly simultaneously with no slowdown
?Notice:?
???OBD2 will not allow data packets to be sent to two different devices at once as it will always see it as one connected device.
Specification:
OBD II cable splitter, signal splitter.
Head type: OBD2
Car side: J1962 Male
Device side: J1962 Female
Allows three devices to be connected simultaneously.
Wire: 16 Pin-to-Pin
Extension length:
50cm 20"
Package Included:
1 x OBD2 OBDII Full 16 Pin Male to 3 Female 1 to 3 OBD Cable With ON/OFF Switch